What F07 actually means
The control board has spotted a problem on the heating side of the circuit, so the machine stops mid-wash rather than carrying on cold.
On an Indesit washing machine, F07 points at the heating circuit as seen from the control board — typically the relay that switches the heater on, or the wiring between board and element. The usual picture is a cycle that pauses partway through with cold water in the drum, and on some machines the drain pump running on and on. The board holds the programme there because it cannot confirm the heater is being controlled properly.
What usually causes it
- Failed heater relay on the main control board
- Damaged or corroded wiring between the board and the heating element
- Faulty heating element or its temperature sensor
- Water or detergent damage to the control board
- Occasionally a one-off glitch that clears after a power-off
What you can safely check yourself
Work through these in order. Anything beyond this — panels off, testing parts, anything to do with the wiring — is an engineer's job, and not one to attempt with the machine plugged in.
- Turn the machine off at the wall for a minute, then power it back up and try a short cycle to see whether the code returns
- If the drum still holds water, run a drain or spin-only programme to clear it before doing anything else
- Note at what point in the cycle it stops and whether the water ever gets warm — that saves the engineer time
When to call someone
This one usually needs an engineer once you have tried the checks above. We cover Nottinghamshire, Derbyshire and Leicestershire, and it's £66 including VAT for an engineer to come out and diagnose it — £84 in total if it's repaired on the visit with no parts needed. Any parts needed are quoted on site before we fit them — you decide. Every repair carries a 90-day workmanship guarantee.
Outside our area? The explanation above still stands — take it to a local engineer and tell them the code. Knowing it saves them time and you money.
Other Indesit washing machine codes
- Indesit F01 — The machine has spotted an electrical fault in the part of t…
- Indesit F02 — The machine has stopped because it can't drive the drum prop…
- Indesit F06 — The machine can't confirm the door is locked, so it won't st…
- Indesit F08 — The machine has a problem with the water heating side of thi…
- Indesit F09 — The washing machine's control board has lost or corrupted th…
- Indesit F11 — The machine can't see the drain pump electrically at all, so…
- Indesit F12 — The machine's control board and its display/selector unit ha…
- Indesit F13 — On an Indesit washer dryer, F13 means the machine can't get …