Montpellier tumble dryer keeps stopping

What is actually happening

A dryer that runs and then stops is usually protecting itself. The thermal cut-out trips when air cannot move freely, and on condenser models a full water container will halt the cycle by design. Both come back the moment you press start, which is why this fault feels intermittent when it is actually completely consistent.

The Montpellier fault codes that point at this

A Montpellier tumble dryer will usually tell you what it thinks is wrong before anyone opens it up. These are the codes we hold for this make that relate to keeps stopping:

• E09 — The machine has decided the electricity reaching it is outside the range it will work with, so it has stopped the programme rather than carry on.
• E14 — The drying side of the machine isn't getting hot, so the control board has abandoned the dry cycle.
• E15 — The machine has sensed the drying air getting hotter than it should and has shut the drying part of the cycle down to protect itself.
• E16 — The machine has measured a higher temperature than it should reach during the drying part of the cycle, so it has shut the heat off and stopped.

If yours is showing one of those, that is a much shorter conversation than a general fault — tell us the code when you book and the engineer can often carry the part.

The usual causes on a Montpellier tumble dryer

• A thermal cut-out tripping on restricted airflow
• A full water container on a condenser model
• A blocked filter, condenser or vent hose
• Moisture sensors reading the load as dry and ending the cycle early
• An intermittent door switch

What you can safely check yourself

1. Empty the water container and clean the filter and condenser
2. Time how long it runs before stopping — the same interval every time points at a thermal cut-out
3. Wipe the sensor bars inside the door with a little white vinegar

Common questions

Why is my Montpellier tumble dryer keeps stopping?

The dryer starts, runs for a while, then stops before the cycle has finished. A dryer that runs and then stops is usually protecting itself. The thermal cut-out trips when air cannot move freely, and on condenser models a full water container will halt the cycle by design. Both come back the moment you press start, which is why this fault feels intermittent when it is actually completely consistent.

Can I fix a Montpellier tumble dryer keeps stopping myself?

Empty the water container and clean the filter and condenser. Time how long it runs before stopping — the same interval every time points at a thermal cut-out. Wipe the sensor bars inside the door with a little white vinegar. Those checks fix it more often than not.

What Montpellier error codes mean keeps stopping?

Montpellier tumble dryers report this through their own fault codes. The ones that point at keeps stopping are E09, E14, E15, E16. If your machine is showing one of those, that narrows it down considerably — each has its own guide on this site.

How much does a Montpellier tumble dryer repair cost?

£66 including VAT for an engineer to come out and diagnose it, or £84 in total including VAT if it is put right on the visit and no parts are needed. Any parts needed are quoted on site before we fit them — you decide. Every repair carries a 90-day workmanship guarantee.

Other Montpellier tumble dryer faults

• tumble dryer not heating
• tumble dryer not drying the clothes
• tumble dryer drum not turning
• tumble dryer making a noise
• tumble dryer will not start
• tumble dryer burning smell

Repairs we cover near you

• Tumble Dryer Repairs — what we charge and how it works
• Tumble Dryer Repairs in Nottingham
• Tumble Dryer Repairs in Beeston
• Tumble Dryer Repairs in West Bridgford
• Tumble Dryer Repairs in Hucknall

Written by the engineers at ASAP Repairs from our own repair notes. See also our general guide to tumble dryers keeps stopping and our Montpellier repairs page.