What E44 actually means
On a Beko washer-dryer, this points at the small water valve that rinses out the condenser during drying he being blocked isn't clearing fluff away.
During the drying part of the cycle, the machine periodically flushes the condenser with water to wash away lint and help it shed heat. The control board has decided that flush isn't happening ot water isn't getering through the condenser washing valve, so it stops the programme rather than let the condenser clog and overheat. Washing normally still works; it is the drying side that fails.
What usually causes it
- The condenser washing valve is blocked with scale or fluff
- The valve has failed electrically and no longer opens
- The condenser itself is clogged with lint, so water cannot pass through
- Poor or restricted water supply to the machine
- A fault on the control board circuit that drives the valve
What you can safely check yourself
Work through these in order. Anything beyond this — panels off, testing parts, anything to do with the wiring — is an engineer's job, and not one to attempt with the machine plugged in.
- Turn the machine off at the wall for a minute, then restart to see if the code clears
- Check both taps are fully open and the inlet hoses are not kinked or trapped behind the machine
- Clean the pump filter at the bottom front and clear the fluff out of it
- Run a wash-only programme to confirm the fault is limited to drying
When to call someone
This one usually needs an engineer once you have tried the checks above. We cover Nottinghamshire, Derbyshire and Leicestershire, and it's £66 including VAT for an engineer to come out and diagnose it — £84 in total if it's repaired on the visit with no parts needed. Any parts needed are quoted on site before we fit them — you decide. Every repair carries a 90-day workmanship guarantee.
Outside our area? The explanation above still stands — take it to a local engineer and tell them the code. Knowing it saves them time and you money.
Other Beko washing machine codes
- Beko C01 — C01 isn't a fault oown as you hold the buttons to switch th…
- Beko C02 — C02 isn't a fault \u2014 it's the middle of a three-second c…
- Beko C03 — C03 isn't a fault at all — it's the first digit of a three-s…
- Beko C04 — The drum has not been able to spin properly because the load…
- Beko C07 — The machine's control boards have stopped talking to each ot…
- Beko E00 — On a Beko washing machine E00 isn't a fault at all — it mean…
- Beko E01 — The machine can't get a sensible reading from the sensor tha…
- Beko E02 — The machine can't heat the water — the heating element or it…